Kirby Air Conditioner 5 User Manual download pdf (Page 14)

KMACS 5 MANUAL

2.2 FIRST USE OF THE KMACS 5

Place the Dive Control System on a ﬁrm surface.

The KMDSI logo should be right side up. Release

the latches and lift up the lid to expose the panels.

When using the KMACS 5 aboard a vessel subject to

waves or swell be sure to tie the KMACS 5 securely

in position so that it doesn’t fall. Thread a piece of

line through the handles and fasten the ends to ﬁt-

tings on the boat. Tie back the lid of the KMACS 5

as well to prevent damage or injury.

2.3 CONNECTING THE AIR SUPPLY

Loosen the knurled knobs which connect the yokes

to their storage posts in the KMACS 5 and remove

the yokes (S) from the blocks. Attach each yoke

to a high pressure cylinder as you would connect

a scuba regulator to a tank. The knobs on the yoke

should be screwed down ﬁnger tight. Do not apply

Section 2.0

2.1 UNPACKING THE KMACS 5

When you ﬁrst receive your KMACS 5, carefully

unpack it and examine it for any damage that may

have occurred during shipment. Be sure to complete

the enclosed warranty card and return it to KMDSI

immediately. No warranty claims will be honored

without a satisfactorily completed warranty card on

ﬁle at KMDSI.

Visually check the KMACS 5 to ensure that it has

not been damaged in transport.

Fig. 6 Connecting a scuba air supply to the KMACS 5.

Fig. 5 Note the line which passes through the handle of the

KMACS 5 and is secured to the rail to prevent the KMACS 5

from moving about.

OPERATING INSTRUCTIONS

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 30 31

No comments

Kirby Air Conditioner 5 User Manual Page 14