Kirby Sentria User Manual download pdf (Page 11)

CAUTION:

Do not pick up heavy objects, such as coins, screws, rocks or similar

objects. This may damage the fan.

Getting Started

USING THE BELT LIFTER (cont)

To use the Belt Lifter, you must first raise the Headlight

Hood



21 . ➤

Flip out the handle on the Belt Lifter



20 . Use it to turn the Belt

Lifter fully to the left (counter-clockwise) until it stops and the red

arrows line up. This stretches the belt and lifts it off the motor shaft.

Return the handle on the Belt Lifter to its closed position.

If you are using your Sentria

system as a straight suction cleaner,

simply lower the Headlight Hood. The Brush Roll is now disengaged

and will not rotate when the power switch is turned ON. ➤

The belt will be stretched to the top of the nozzle as shown. ➤

To re-engage the belt so the Brush Roll rotates, simply raise the

Headlight Hood and use the handle to turn the Belt Lifter fully

to the right (clockwise) until the green arrows line up. Then lower the

Headlight Hood.

The Brush Roll will now rotate when the Power Switch is turned ON.

NOTE: The belt should not be stretched when stored for an extended

period. Make sure the green arrows line up for storage. ➤

Your Sentria system is equipped with a Brush Roll Performance

Indicator Light



7 , located on the top right side of the Power

Nozzle. The purpose of this light is to show if the Brush Roll is

rotating properly.

If the Brush Roll Indicator Light flashes intermittently or does not come

on when using the Power Nozzle, the Brush Roll Belt may not be work-

ing properly. Either the Belt is not engaged or may need to be replaced.

To replace the Brush Roll Belt, also called the Power Nozzle Belt, see

Page 40. ❏

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 57 58

No comments

Kirby Sentria User Manual Page 11