Kirby Sentria User Manual download pdf (Page 21)

When using the blower attachments, the Air Intake Guard must

be attached to the front of the unit.

Fasten the Air Intake Guard onto the Attaching Bar



24 the same way

you would the Attachment Hose. Then lock it on by turning the

Accessory Lock



22 all the way to the right (clockwise). Than

lower the Headlight Hood. ➤

Unlock the Power Nozzle



25 by turning the Accessory Lock



all the way to the left (counter-clockwise). The Power Nozzle

should tip forward when it is released. Lift nozzle away from the

Sentria system. ➤

BLOWER SET-UP (cont)

Raise the Headlight Hood



21 and flip out the handle on the Belt

Lifter



20 . Use it to turn the Belt Lifter all the way to the left

(counter-clockwise) until the red arrows line up. ➤

Canister Cleaner & Attachments

Place the large end of the Attachment Hose over the Air Exhaust

Port



19 . Line up the Indicator Arrow on the Hose End with the

Indicator Arrow on the Air Exhaust Port and twist the Hose Connector

to the right (clockwise) to lock it in place.

If the Sentria system will not operate, see page 44. ❏

To remove the entire Bag Assembly, grasp the Mini Em-Tor

collector



6 in the hand-hold provided and rotate it out and away

from the Sentria

system as far as it will go. Then lift it off.

Release the Outer Permanent Bag Top from the Bag Support by pressing

the Bag Release Button



16 and sliding the bag top down. ➤

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 57 58

No comments

Kirby Sentria User Manual Page 21