Kirby Sentria User Manual download pdf (Page 34)

KIRBY MIRACLE WAX DIRECTIONS

For Hardwood, Vinyl, Cork and Linoleum Floors:

1. Clean surface thoroughly.

2. Attach Kirby Floor Care System Buffer Nozzle and

Brush according to the instructions on page 34,

under ‘‘Floor Buffer Set-Up.”

3. For best results, apply a very thin coat of Kirby

Miracle Wax using the roller applicator. It is not

necessary to completely cover the floor with wax at

this time, as the wax will be spread in the next step.

4. Using the Toe-Touch Control Upper Pedal to lower the

nozzle all the way down, spread the wax evenly over

the entire floor using the Kirby Floor Care System

Buffer Brush.

5. Let dry 5 minutes.

6. When dry, buff with the Kirby Floor Care System

Buffer Brush.

NOTE: For very worn areas, two coats may be re quired.

In this case, multiple thin coats will provide better

results than one thick coat.

For Marble Floors:

Apply a thin coat and spread as in the directions in #4.

However, buff immediately, avoiding any drying time.

Once you have completed the steps above, the floor

may be rebuffed, any time it becomes necessary, using

the Floor Care System Buffer Brush. Apply additional

wax ONLY when rebuffing does not produce

acceptable results.

IMPORTANT:

Do not use Kirby Miracle Wax on rubber

or asphalt tile. ❏

If desired, prepare the long waxer roller handle for storage by

depressing the spring-loaded pin on the lower portion of the handle

while pushing the upper portion toward the hooked end.

IMPORTANT: Seal used roller in original packing bag and tube after

each use to prevent the wax from drying out. ❏

Grasp both the packing bag and roller firmly and pull them off the

long roller waxer handle. To do this, push the roller away from the

handle grip toward the bar to compress the retaining spring. This will

allow you to slide the roller over the end cap. Seal bag tightly to prevent

premature drying. Store in the provided packing tube and put in a safe

place away from children and pets until next use. ➤

Optional Accessories

USING THE MIRACLE WAXER

FLOOR POLISHER (cont)

To remove the wax roller from the long handle, hold the original

wax roller packing bag with the open end facing the roller.

Push the wax roller into the packing bag as far as it will go.

Avoid touching the wax with your hand. ➤

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 57 58

Comments to this Manuals

No comments

Kirby Sentria User Manual Page 34

Comments to this Manuals