Kirby Sentria User Manual download pdf (Page 42)

CHANGING THE POWER NOZZLE BELT (cont)

Slide off the old belt and replace with a new one. ➤

Operating/Maintenance Tips

Make sure the Brush Roll Bristle Height Adjustment setting

(1, 2, or 3) is the same on both ends as when the brush was

removed. See below for discussion of the Brush Roll Bristle

Height Adjustment (1, 2, or 3). Place the belt and Brush Roll back

into the nozzle. One of the plastic Brush Roll ends is larger than the

other, thus the Brush Roll will only fit in the nozzle one way.

Then center the belt on the Brush. ➤

Replace the Rug Plate by placing it on the front of the bumper

first and then pulling it over the bumper on the rear of the Power

Nozzle



25 . Secure the Rug Plate using the two latches that hold

it in place. ➤

Using the handle on the Belt Lifter



20 , turn it to the left (counter-

clockwise) until the red arrows line up. This will stretch the belt in

preparation for returning the nozzle to the Sentria

system.

Now you are ready to re-attach the Power Nozzle and re-engage

the belt. ❏

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 57 58

No comments

Kirby Sentria User Manual Page 42